Carb sync tubing update

I’ve had a lot of people ask whether the clear vinyl tubing used in the carb sync mod holds up over time. Since I had the tank up for the 32k mile service last weekend, I took some pictures and then updated the write-up. The update is down at the bottom.

And, hey, I’m still looking for pictures from a 49-state model bike with this mod. If anyone’s done this to a non-California bike, can you take some shots of the rear carb connector and email ’em to me, so I can put them on the site? I’ll give full credit, of course. 😉

This entry was posted in Wrenching. Bookmark the permalink.

Leave a Reply

Your email address will not be published.