386_8610.JPG:All the parts you'll need 386_8613.JPG:Where the horn goes -- it should be connected to that hanging wire in front of the radiator. 386_8615.JPG:SVS with the front/side fairings removed 386_8616.JPG:This is the room you'll have to work with (between the headlights and radiator) 386_8619.JPG:I decided to mount the horns on the lower fork mounting bolts 386_8620.JPG:Horns in their tentative positions 386_8621.JPG:Testing out the horn mounting places 386_8622.JPG:Checking that the horns won't interfere with the fairing 386_8624.JPG:Wiring diagram for the two horns 386_8626.JPG:Wires with spades attached 386_8628.JPG:Testing to make sure the spades fit on the horns 386_8630.JPG:Male connector end 386_8631.JPG:The three black pieces of wire, pre-solder 386_8632.JPG:Black wires, ready for soldering 386_8633.JPG:A decent enough solder joint 386_8634.JPG:The finished Y-shaped black wiring 386_8635.JPG:Male connector tip and the end of the black "Y" 386_8637.JPG:Finished wiring 386_8638.JPG:Male (left) and female (right) .093" 3-pin Molex connectors 386_8640.JPG:Female connector attached to our wiring 386_8641.JPG:Stock horn connector 386_8643.JPG:Horn wiring with the connector cut off and the wires stripped 386_8645.JPG:Female connector ends 386_8648.JPG:Female connector ends on the stock horn wiring 386_8649.JPG:Female connector attached to the stock horn wiring 386_8651.JPG:Horns connected to the bike 386_8653.JPG:Horns wired up and mounted in place 386_8654.JPG:Horns wired up and mounted in place 386_8655.JPG:Finished product: horned mounted and wires zip-tied out of the way 386_8686.JPG:Top view of the mounted horns